My Router internet connectivity is very unstable from last 1 month.

My Router internet connectivity is very unstable from last 1 month.

My Router internet connectivity is very unstable from last 1 month.
My Router internet connectivity is very unstable from last 1 month.
2024-05-28 03:02:46 - last edited 2024-05-29 03:54:14
Model: Archer MR200  
Hardware Version: V5
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 210120 Rel.67320n

My internet is working only in PDP Type - IPv4, which is very unstable. And when i shift it to IPv4 & IPv6 there where is not internet. I am facing this issue from last 1 month. i tried all DNS Setting  but is didn't worked.

  0      
  0      
#1
Options
1 Reply
Re:My Router internet connectivity is very unstable from last 1 month.
2024-05-29 03:53:00

  @AkashGupta 

 

Hi, thanks for posting question here.

Multiple factors might cause the disconnect automatically. For the LTE disconnecting issue, please try the following steps for troubleshooting:

    1. If the band was changing to a different one when the internet interrupts, select a 4G LTE band(s) manually on Advanced > Network > Internet page and change the Band from "Auto" to "Manual". If your LTE router doesn't support manual band selection, you could get the beta firmware from this thread.

    2. You may try to change the Network Type on Advanced > Network > Internet page from 4G Preferred to 4G Only.

    3. Please insert the same SIM into another LTE device or even a smartphone to check if the SIM has a problem.

If the LTE connection is fine, only the wireless client devices are unstable while connecting to the router:

    1. Make sure the Router is properly placed, it should be put in an open area instead of inside a cabinet or shelf.

    2. log in to the web management interface of the Router, go to Advanced > Wireless > Wireless Settings, and change the wireless channel to another one.

    3. For 2.4GHz wireless client devices, adjust 2.4GHz channel width into 20MHz, for 5G wireless client devices, adjust 5GHz channel width into 80MHz or 40MHz to avoid interference.

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 173

Replies: 1

Related Articles