How do I enable 'bypass mode' with this router?
I have installed a TL-MR6400 Router in an office detached from our house. It is connected by ethernet cable to our main wifi router in the house, but am advised that this may cause communication problems due to double NAT (not really sure what this means!) . I am advised to reset the office Router in 'bypass mode' to eliminate this problem. How do I do this with the TL-MR6400 Router?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, thanks for posting question here.
It is a pity that the router only supports 3G/4G Router Mode and Wireless Router Mode. Usually, a normal wireless router supports both wirelss router mode and Access Point mode. With using AP mode, you can avoide double-NAT with your main wireless router.
- Copy Link
- Report Inappropriate Content
Thanks Marvin - yes I understand that 'Bypass Mode' should allow avoiding Double Nat which has been causing problems with my main Router. I was hoping that some one could tell me how to do this with my secondary TP-Link TL-MR6400 router i.e. how does one set it to Bypass Mode?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 546
Replies: 4
Voters 0
No one has voted for it yet.