Archer VR2100 vs WD4TB on NTFS
Hello,
I'm using router Archer VR2100 form few years,
I had connected hard drive WD 4TB with one NTFS partition to it for a long time,
From few weeks I have a new problem with it,
Drive is connected (as it was before), router can "see it", identify as WD Elements 2621, 3,6TB but... Aveliable 0,0 GB
If I will go to "drive shearing" it also shows that I can share 0GB
Of course I have connected hard drive directly to computer and it works without any problem - free space on drive 2,7TB
Maybe somebody have some ideas what can be the problem here?
It is something similar to topic
https://community.tp-link.com/en/home/forum/topic/229374
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Ok, that could be the case but would then the same effect was when I connect drive to pc directly?
When I have try that connection - drive works normally, without any problem,
All data was there,
I was thinking about power level
Is it possible that voltage level on usb port in router is too low?
I understand that all electronical devices are waring out so maybe that could be the problem?
I thought that maybe I should buy usb connector with external power supply - what do You think?
- Copy Link
- Report Inappropriate Content
Hi,
Active USB hub have resolve the issue - so the problem was with limitation of power output from original USB connector in router,
Easy to fix - all equipment works,
Thanks for support,
Best Regards
Adam
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
I have tryed this firmware and still no effect,
This is what I have when I open "USB Devices"
Simultaneously i have this on main "Network map"
And the most strange thing - it works normally few weeks ago...
- Copy Link
- Report Inappropriate Content
I could only assume but probably something has gone wrong while using the HDD - power outage, wrongly recorded data, etc.
If that's the case reformatting the HDD probably may help.
- Copy Link
- Report Inappropriate Content
Ok, that could be the case but would then the same effect was when I connect drive to pc directly?
When I have try that connection - drive works normally, without any problem,
All data was there,
I was thinking about power level
Is it possible that voltage level on usb port in router is too low?
I understand that all electronical devices are waring out so maybe that could be the problem?
I thought that maybe I should buy usb connector with external power supply - what do You think?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
Active USB hub have resolve the issue - so the problem was with limitation of power output from original USB connector in router,
Easy to fix - all equipment works,
Thanks for support,
Best Regards
Adam
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 552
Replies: 6
Voters 0
No one has voted for it yet.