Home Network Community > All Threads > AX55 hangs
< All Threads

AX55 hangs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX55 hangs

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AX55 hangs
AX55 hangs
2024-04-22 08:11:29 - last edited 2024-04-23 08:18:36
Model: Archer AX55  
Hardware Version: V1
Firmware Version: 1.2.6 Build 20231130 rel.36135(4A50)

I bought this router about 2 years ago and since some time ago (unfortunately I'm not sure since when) the routers sometimes becomes un-operational - the Internet connection drops, the LAN connections also don't work, the web portal doesn't load anymore, but the router still responds to pings. This happens sometimes, and the only thing that helps is to power cycle the router. I can't seem to make any connection as to what might be causing this. Any logs from before this seem to be gone after it boots up again but the configuration stays intact as far as I can tell. One thing I noticed today when it happened again is that the time resets to 0 (UNIX timestamp) and recovers in two phases:
 

2024-04-22 16:04:29 Led Controller INFO [1111] Start to run WAN1_ON

2024-04-22 16:04:29 Led Controller INFO [1111] Start to run WAN0_OFF

2024-04-22 16:04:29 Led Controller INFO [1111] Start to run LAN_ON

2024-04-22 16:04:10 Led Controller INFO [1111] Start to run NIGHT

2024-04-22 16:04:10 Led Controller INFO [1111] Start to run NIGHT

2023-11-30 00:02:33 UPnP INFO [20504] Service start

2023-11-30 00:02:33 UPnP INFO [20504] Service stop

...

2023-11-30 00:00:00 Time Settings INFO [1280] Service start

1970-01-01 00:00:33 Led Controller INFO [1111] Start to run STATUS_SAN

1970-01-01 00:00:32 Led Controller INFO [1111] Service start

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:AX55 hangs-Solution
2024-04-23 07:54:43 - last edited 2024-04-23 08:18:36

  @mouuro 

 

 

Don't worry about that - check this post. This already has been tested on AX55 v1. You can start with that first.

If the issue persists, I would recommend to make a configuration backup before attempting a factory reset.

You can configure only basic settings and test the AX55 behavior. If everything's OK, do a configuration restore and test again.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  0  
  0  
#4
Options
4 Reply
Re:AX55 hangs
2024-04-23 06:01:17

  @mouuro 

 

Have you tried to reset the router to its factory defaults, re-configure from scratch and test if there's any difference.

You can also try the latest stable FW release v1.3.1 from this link and check if there's an improvement.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options
Re:AX55 hangs
2024-04-23 07:28:32

  @terziyski I haven't tried factory reset yet, and re-configuring from scratch would be a huge pain because I don't remember everything that I did, and have a lot settings especially DHCP reservations in place. Do you think restoring from configuration backup instead of manually could potentially help as well?

Also my update firmware page shows "Firmware is up to date." after checking for updates. It seems that this new version is only available on the Taiwan site, and the site itself states to use only firmware from the region that the device has been bought in and mine wasn't bought in Taiwan.

My device is barely out of warranty so I don't care about voiding it anymore, just cautious about potentially bricking it, but I can't wrap my head around why would such notice be there given that the firmware file is exactly the same across those different sites for the previous version.

  0  
  0  
#3
Options
Re:AX55 hangs-Solution
2024-04-23 07:54:43 - last edited 2024-04-23 08:18:36

  @mouuro 

 

 

Don't worry about that - check this post. This already has been tested on AX55 v1. You can start with that first.

If the issue persists, I would recommend to make a configuration backup before attempting a factory reset.

You can configure only basic settings and test the AX55 behavior. If everything's OK, do a configuration restore and test again.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  0  
  0  
#4
Options
Re:AX55 hangs
2024-04-23 08:32:27

  @terziyski 

 

I've updated the firmware without any problems and will see if this happens again, but since this issue was not happening very often in the first place let's consider this solved until that then.

 

Thank you.

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 619

Replies: 4

Related Articles
AX55 information
551 0
AX55 Onemesh
2196 0
AX53 and AX55 differences
42506 4
2 AX55 - OneMesg
1295 1
AX55 Configuration for Movistar
1531 0
AX55 SSID and password
573 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.