PA4010 Failing to Link

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

PA4010 Failing to Link

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
PA4010 Failing to Link
PA4010 Failing to Link
2024-02-17 22:46:15 - last edited 2024-02-27 09:06:21
Model: TL-PA4010 KIT  
Hardware Version: V3
Firmware Version:

The middle light on both devices went out, which I was able to figure out means the pair are no longer linking up to each other. I've tried to reconnect the units by pressing the connect button on the front, reset both by holding it down for ten seconds, un-plugged both units and plugged them back in and pressed the button again. None of the above seem to be working for me, however.

 

Is there anything else I can try at this point in time?

  0      
  0      
#1
Options
1 Accepted Solution
Re:PA4010 Failing to Link-Solution
2024-02-17 23:39:59 - last edited 2024-02-27 09:06:21

  @Prole 

 

Hi,

 

Plug both TL-PA4010 into wall sockets that are very close to each other, or into an extension strip with multiple sockets. Then try again to pair them. If they still fail to pair, then one of them must have gone bad.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:PA4010 Failing to Link-Solution
2024-02-17 23:39:59 - last edited 2024-02-27 09:06:21

  @Prole 

 

Hi,

 

Plug both TL-PA4010 into wall sockets that are very close to each other, or into an extension strip with multiple sockets. Then try again to pair them. If they still fail to pair, then one of them must have gone bad.

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 444

Replies: 1

Related Articles