AV600 Powerline continuously reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AV600 Powerline continuously reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AV600 Powerline continuously reset
AV600 Powerline continuously reset
2024-01-31 19:04:50

I plugged the AV600 adapter (TL-PA4010) into a power outlet and connected it to the router. Then I plugged the extender (TL-WPA4220) into a power outlet. I started the pairing and looking at the LEDs everything seemed ok but after few seconds the LEDs of the extender turned off like it was reset. The reset is continuously triggered after few seconds. I tried different power outlets but the result is the same

  0      
  0      
#1
Options
1 Reply
Re:AV600 Powerline continuously reset
2024-02-01 02:53:46

  @Npastori 

 

Hi, do you mean all LEDs on the extender will turn off and then power starts flashing and other LEDs turnning on later, then after few seconds, the whole process repeats?

Please try resetting the powerline extender by holding the Reset button until all LEDs turnning off and start on again.

 

After that, please don't pair it yet with the powerline adapter, leave it plugged and check if it keeps rebooting itself or not.

 

By the way, was the powerline extender working fine before?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 656

Replies: 1

Related Articles