Deco setup as AP connected to ER605 router.

1. All devices connected to ER605 has internet access - no problems.

2. All decos connected to ER605 detected by router normally.  All Decos successfully received IP address. Decos are connected via wired backhaul on gigabit ethernet.

3. All wifi devices connected to Deco has internet access and can access at full speed - all working fine.

4. Deco itself is reporting that it has IP address but has no internet access - which is false.  Just misreporting it as all the devices connected to it can go to the internet.

4.1 Because it is misreporting its internet status, it can no longer Check for updates; and its status light is now RED color 

4.2 I have tried rotating the Deco nodes - I have 4 in total, all behave the same.

4.3 When Deco is set as router mode, everything works fine, it can check for updates.

4.4 thus at this stage this is not a "deal-breaker" as all devices has internet access going thru the Deco. It is just inconveniet if I need to check for firmware updates, which I need to switch it to router mode and connect it to the modem.  

4.5 because the Deco thinks it is not connected to the internet, it also cannot schedule turning off the indicator lights.

Please fix.