4G+ led is not active

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

4G+ led is not active

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

boldorv

2023-08-17 15:06:52 - last edited 2023-08-18 08:56:45

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-08-17

4G+ led is not active

2023-08-17 15:06:52 - last edited 2023-08-18 08:56:45

Tags: #Carrier Aggregation

Model: Archer MR600

Hardware Version: V3

Firmware Version:

Hello

How can I configure my Archer to have 4G+ active ?

Thanks

1 Accepted Solution

Sunshine

2023-08-18 08:56:24 - last edited 2023-08-18 08:56:29

Posts: 7375

Helpful: 1226

Solutions: 940

Stories: 0

Registered: 2018-12-17

Re:4G+ led is not active-Solution

2023-08-18 08:56:24 - last edited 2023-08-18 08:56:29

@boldorv

Hi, 4G+ or carrier aggregation is enabled by default on MR600, but whether it will work on 4G+ depends on the base station as well, if there is any issue, please refer to this post for troubleshooting:

Carrier Aggregation or 4G+ doesn’t work properly on LTE Advanced Router

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

Information

Helpful: 0

Replies: 1

4G+ led is not active

4G+ led is not active

Information

Voters 0

Tags