Home Network Community > All Threads > Port Forwarding
< All Threads

Port Forwarding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Port Forwarding

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Port Forwarding
Port Forwarding
2023-07-18 07:34:23 - last edited 2024-09-12 08:07:23
Tags: #Port Forwarding #NAT Forwarding
Model: Archer MR600  
Hardware Version: V1
Firmware Version: 1.2.0 0.9.1 v0001.0 Build 200511 Rel.44954n

I have set up port forwarding to access my Home Assistant router remotely, but it doesn't seem to be working. I would expect that typing in my IP address to a browser would get me to the HA login screen. But I just get a timeout. Internal IP and internal port below are correct for my Home Assistant server - these are what I use to access it locally. Have already turned off NAT boost as I read that this could cause an issue. Any advice much appreciated.

 

port forwarding

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Port Forwarding-Solution
2023-07-19 06:52:24 - last edited 2023-07-26 08:33:14

  @justinsw 

 

If your MR600 Internet IP address is different than your public IP address then you're probably behind double NAT or CG-NAT.

The only possible solution is to contact your ISP (mobile service provider) and ask him if he could provide a public IP address for your MR600.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  2  
  2  
#3
Options
2 Reply
Re:Port Forwarding
2023-07-18 10:56:27

found an old thread here: https://community.tp-link.com/en/home/forum/topic/593280. My public IP address (which duckdns shows) is different from the IPV4 address that I see in my router settings. What's that about and does it make a difference?

  0  
  0  
#2
Options
Re:Port Forwarding-Solution
2023-07-19 06:52:24 - last edited 2023-07-26 08:33:14

  @justinsw 

 

If your MR600 Internet IP address is different than your public IP address then you're probably behind double NAT or CG-NAT.

The only possible solution is to contact your ISP (mobile service provider) and ask him if he could provide a public IP address for your MR600.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  2  
  2  
#3
Options

Information

Helpful: 0

Views: 1122

Replies: 2

Tags

Port Forwarding
NAT Forwarding
Related Articles
Port forwarding problems on Archer MR200
213 0
Minecraft port forwarding not working
943 0
Port Forwarding is not working on my modem
657 0
Port forwarding
683 0
Port Forwarding
1001 0
Port Forwarding
872 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.