Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > Access Point Mode and using different subnet

< All Threads

Access Point Mode and using different subnet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Access Point Mode and using different subnet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Orkney_lad

2023-06-06 19:34:03 - last edited 2023-06-08 06:46:09

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-06-06

Access Point Mode and using different subnet

2023-06-06 19:34:03 - last edited 2023-06-08 06:46:09

Tags: #Access Point Mode

Model: Archer C64

Hardware Version:

Firmware Version:

I have fibre coming into the house from a router with a gateway of 192.168.1.1. I have run an ethernet cable from this router to my office at the bottom of the garden and connected my Archer C64 (ethernet into WAN port). I would have liked the Archer C64 set up to give out addresses in the range 192.168.3.xx keeping the 2 networks separate. The gateway would be 192.168.1.1. Is there any way that this could be set up?

1 Accepted Solution

terziyski

LV7

2023-06-07 06:28:11 - last edited 2023-06-08 06:46:09

Posts: 7142

Helpful: 5361

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:Access Point Mode and using different subnet-Solution

2023-06-07 06:28:11 - last edited 2023-06-08 06:46:09

@Orkney_lad

Yes, there is - you just have to use your C64 in "wireless router mode" instead and set it's LAN IP address in 192.168.3.0/24 subnet.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Recommended Solution

2 Reply

terziyski

LV7

2023-06-07 06:28:11 - last edited 2023-06-08 06:46:09

Posts: 7142

Helpful: 5361

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:Access Point Mode and using different subnet-Solution

2023-06-07 06:28:11 - last edited 2023-06-08 06:46:09

@Orkney_lad

Yes, there is - you just have to use your C64 in "wireless router mode" instead and set it's LAN IP address in 192.168.3.0/24 subnet.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Information

Helpful: 0

Replies: 2

Access Point Mode and using different subnet

Access Point Mode and using different subnet

Information

Voters 0

Tags