Which powerline adapters are compatible with PX50 ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Which powerline adapters are compatible with PX50 ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Which powerline adapters are compatible with PX50 ?
Which powerline adapters are compatible with PX50 ?
2023-04-11 13:36:30 - last edited 2023-10-09 09:45:31
Model: Deco PX50  
Hardware Version:
Firmware Version:

I recently purchased a quite expensive set of 3 Deco PX50 routers. They work well within my flat, but I want to extend the network into my basement room using the powerline connectivity. I know that the PX50 are not compatible with normal HomePlugAV. So do I have to purchase another expensive PX50 router just for a small basement room or are there other routers that would work?
And even if I had to buy another PX50, why is there no listings for a SINGLE PX50 router on any shopping site I checked? I do NOT need another pair or even three of them, only ONE!

  1      
  1      
#1
Options
1 Accepted Solution
Re:Which powerline adapters are compatible with PX50 ?-Solution
2023-04-12 07:46:03 - last edited 2023-10-09 09:45:31

  @kintrupf 

Hi, welcome to the community.

You could have a look at PGW2440 KIT

https://www.tp-link.com/en/home-networking/powerline/pgw2440-kit/

And the expected layout would be like this:

Internet---ISP modem---main Deco PX50---<cable>---PG2400P~~~home wire system~~~PGW2440(in the basement)

If you only want to have one SSID, you could change the WiFi name of PGW2440 to the same as Deco PX50.

Thank you very much.

Best regards.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Which powerline adapters are compatible with PX50 ?-Solution
2023-04-12 07:46:03 - last edited 2023-10-09 09:45:31

  @kintrupf 

Hi, welcome to the community.

You could have a look at PGW2440 KIT

https://www.tp-link.com/en/home-networking/powerline/pgw2440-kit/

And the expected layout would be like this:

Internet---ISP modem---main Deco PX50---<cable>---PG2400P~~~home wire system~~~PGW2440(in the basement)

If you only want to have one SSID, you could change the WiFi name of PGW2440 to the same as Deco PX50.

Thank you very much.

Best regards.

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 1

Views: 1079

Replies: 1

Related Articles