Archer MR500 - 1000-2000 ping spike every 10 seconds consistently

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR500 - 1000-2000 ping spike every 10 seconds consistently

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-04-03 05:47:48 - last edited 2023-08-28 09:43:04
Model: Archer MR500  
Hardware Version: V1
Firmware Version: 1.0.0.0.9.1 v0001.0 Build 220130 Rel.31909n

Good morning all, 

 

My Archer MR500 will ping any website for 30 - 40ms, then will jump to 1000 - 2000ms for a single ping, and then drop back down to 30-40ms. I've tried two different SIM Providers, and if over Wifi and Ethernet. 

I've checked online, and can see that the MR600 version has a Beta Driver to turn off One Mesh, is this also available for the MR 500? Or could this be due to another setting on the 4G Router?



Cheers!

 

 

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently -Solution
2023-04-03 08:25:32 - last edited 2023-08-28 09:43:04

  @Sunshine 

Sorry for the late reply!

So I've updated the MR500 as per your message, and the ping spikes dropped from 1000+ down to 100 - 300. And it looks like the average ping went up by 10ms, but I can live with that if the ping spikes stopped =D !!

Also here is the info from my 6400 as requested: 

 

Device Information
Firmware Version: 
1.4.0 0.9.1 v0001.0 Build 220506 Rel.57555n
Hardware Version: 
TL-MR6400 v5.3 00000002
Online Upgrade
Latest Version: 
1.4.0 0.9.1 v0001.0 Build 220506 Rel.57555n
Internet is unavailable
 

I will use this updated MR500 version for a few days, fingers crossed it resolved the issue! 

Recommended Solution
  0  
  0  
#5
Options
7 Reply
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-04-03 06:04:45

  @HomerAnon 

 

Hi, normally OneMesh will not affect the router performance, you mentioned that Ethernet connection has the same issue, so it is not caused by wireless interference either.

 

Could you please use Ethernet connection to ping LAN IP address of the MR500 as well to see if it is stable? or the issue only happens when pinging public IP/website.

 

By the way, except for the ping issue, is the internet fast and stable?

Which two SIM providers have you tried? If you insert the SIM into a smartphone, then enable phone hotspot, and connect the same computer to the phone hotspot to test the ping, is there any similar issue?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-04-03 06:19:16

  @Sunshine 

Good morning, thanks for the quick reply. 

I started with using a Vodafone Sim, and then switched over to Lebara (same network but cheaper), and then used an EE Sim too. 

 

If I put any on the SIm cards into my personal mobile, the ping is consistent around 55ms. 

However regardless of the Sim provider, putting them into the MR500 will get stable ping first and then one huge spike before dropping back down and repeating. 

 

The ping is only visible when pinging an external website. When I ping my LAN, I get 1ms response without any spikes. 

 

I do have a MR6400 and putting any Sim card into this (like my phone) has no ping spikes. I would prefer to get the MR500 working though, as it gets much better 4G signal strength!

 

  0  
  0  
#3
Options
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-04-03 06:48:59

  @HomerAnon 

 

Hi, may I know the hardware and firmware version of your MR6400 for comparison?

 

In addition, I just sent you a private message, please have a check, if that doesn't help, please email "support.forum@tp-link.com" with subject "Forum 604878" for following up.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#4
Options
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently -Solution
2023-04-03 08:25:32 - last edited 2023-08-28 09:43:04

  @Sunshine 

Sorry for the late reply!

So I've updated the MR500 as per your message, and the ping spikes dropped from 1000+ down to 100 - 300. And it looks like the average ping went up by 10ms, but I can live with that if the ping spikes stopped =D !!

Also here is the info from my 6400 as requested: 

 

Device Information
Firmware Version: 
1.4.0 0.9.1 v0001.0 Build 220506 Rel.57555n
Hardware Version: 
TL-MR6400 v5.3 00000002
Online Upgrade
Latest Version: 
1.4.0 0.9.1 v0001.0 Build 220506 Rel.57555n
Internet is unavailable
 

I will use this updated MR500 version for a few days, fingers crossed it resolved the issue! 

Recommended Solution
  0  
  0  
#5
Options
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-04-03 08:46:59

  @HomerAnon 

Thanks a lot for the update, if there is any further issue about the ping spikes, please let us know.

 

Hope it will work properly.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#6
Options
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-08-25 21:41:34

I have the same problems.

Streaming with Netflix for example, in 2 or 3 min speed drop downs and picture see worse :(

  0  
  0  
#7
Options
Re:Archer MR500 - 1000-2000 ping spike every 10 seconds consistently
2023-08-28 09:44:19

  @ReddyNet 

 

Hi,I just saw you in another thread and has already replied, please have a check: https://community.tp-link.com/en/home/forum/topic/620280?replyId=1245274

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#8
Options

Information

Helpful: 0

Views: 1304

Replies: 7

Related Articles