This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
My X20 slave will not daisy chain to the slave in-between the main X20 and the x20 in question.
I posted this problem last year which a special firmware update was suggested which worked. However, when the deco updated the problem returned.
Many thanks for any help,
Hi, nice to see you again.
Could you please try to install the following firmware of Deco X20 V2 and check whether it will help or not:
https://community.tp-link.com/en/home/forum/topic/264506
And It is also planned to allow manually selecting the signal source on the later firmware upgrade.
Thank you very much.
Best regards.
Helpful: 0
Views: 683
Replies: 1
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
