Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > Archer C6 v2 not working in access point mode

< All Threads

Archer C6 v2 not working in access point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C6 v2 not working in access point mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Baris

2022-05-15 22:44:47 - last edited 2022-06-23 10:07:49

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-05-15

Archer C6 v2 not working in access point mode

2022-05-15 22:44:47 - last edited 2022-06-23 10:07:49

Tags: #Access Point Mode

Model: Archer C6

Hardware Version: V2

Firmware Version:

Hey all,

I've got Archer C6 as an access point to use in my bedroom. The ethernet cable that's coming from the switch is simply connected to the WAN of the C6. The router is set to access point mode but the internet light is still orange! (Meaning no internet)

when I plug the ethernet straight to my desktop, the internet works but not on the Archer c6...

any suggestions?

1 Accepted Solution

terziyski

LV7

2022-05-16 08:25:35 - last edited 2022-06-23 10:07:40

Posts: 7142

Helpful: 5361

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:Archer C6 v2 not working in access point mode-Solution

2022-05-16 08:25:35 - last edited 2022-06-23 10:07:40

@Baris

Here's a guide on how to configure C6 in AP mode.

Keep in mind that C6 LAN IP address should be in the same subnet as your main router.

Setting the C6 LAN IP to Smart IP(DHCP) should be fine.

To exclude problems with your C6 WAN port just move the ethernet cable to one of its LAN ports and test again.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Recommended Solution

1 Reply

terziyski

LV7

2022-05-16 08:25:35 - last edited 2022-06-23 10:07:40

Posts: 7142

Helpful: 5361

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:Archer C6 v2 not working in access point mode-Solution

2022-05-16 08:25:35 - last edited 2022-06-23 10:07:40

@Baris

Here's a guide on how to configure C6 in AP mode.

Keep in mind that C6 LAN IP address should be in the same subnet as your main router.

Setting the C6 LAN IP to Smart IP(DHCP) should be fine.

To exclude problems with your C6 WAN port just move the ethernet cable to one of its LAN ports and test again.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Information

Helpful: 0

Replies: 1

Archer C6 v2 not working in access point mode

Archer C6 v2 not working in access point mode

Information

Voters 0

Tags