Port Forwarding for DVR on TD-W9970
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I All, I am trying to set up port forwarding on my new router. I have a static I.P. Address and the DVR needs port 80 and 8000 open to connect with the internet so I can view cameras on my phone. It was all previously working fine but a router failure means I have to set te router up . I have checked the current static I P address and it is as on my App. I have gone into the router and NAT Forwarding ten Virtual servers and added 2 new entries
1 HTTP 80 192.168.1.67 80 TCP or UDP
2 HTTP 8000 192.168.1.67 8000 TCO or UDP
192.168.1.67 is the internal IP address of te DVR
On my phone I cannot connect to the DVR or see te cameras. I am obviously doing something wrong. Can anybody help please????
Make sure that see your public IP address on your modem router's WAN (Internet) interface:
Make sure that you use for Protocol "All" if it's not working with TCP or UDP.
Make sure that 80 and 8000 are the only two ports that needs to be opened on your modem router.
If not sure set a DMZ to your DVR and test again:
Make sure that see your public IP address on your modem router's WAN (Internet) interface:
Make sure that you use for Protocol "All" if it's not working with TCP or UDP.
Make sure that 80 and 8000 are the only two ports that needs to be opened on your modem router.
If not sure set a DMZ to your DVR and test again: