Deco M4 disconnecting from Mesh
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have home mesh network of 3 M5 and 2 M4 devices (connected to internet via Archer VR600, one of the M5 is connected to the router with cable).
From time to time some units (mostly the M4 ones) disconnect from the mesh (light chnages to red). Other devices are connected and Wifi is working for them.
When I restart them they are connecting back. If nothing is done they connect back after few minutes.
these 2 devices has desktop computers connected to them with lan cable, so computers get disconnected when thi happen.
All devices are updated to latesr Firmware version.
Pleas ehelp to find what might cause these disconnections?
Hi, welcome to the community.
Did all the Deco work under access point and VR600 is the main router/DHCP server?
Can you provide me a layout about your network, such as:
Have you tried to move 2*M4 much closer to main M5, or swap the location with 2*M5 to check whether the disconnection follows the location?
Hi
This is the setting I have.
VR600 is the the router, and all deco are access points.
The single M5 unit (M5b) sometimes connect to the M5c instead of to the main Deco.
I tried to replace between M5c and one of the M4 but it still happen from time to time.
I cannot move the M4 to another location - they are connected to desktop computer.
Thanks.
\Yair.