Home Network Community > All Threads > M4R slave cap at 100Mbps
< All Threads

M4R slave cap at 100Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

M4R slave cap at 100Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
M4R slave cap at 100Mbps
M4R slave cap at 100Mbps
2021-10-10 03:28:34
Model: Deco M4  
Hardware Version: V2
Firmware Version: 1.4.3 Build 20200918 rel 74289

Brand new M4 master unit get 200Mbps is maximum from ISP. But on the 2nd unit (wired to the master) is always cap at 100Mbps?

 

if you need any information I will provide later. 

  0      
 
  0      
 
#1
Options
1 Reply
Re:M4R slave cap at 100Mbps
2021-10-11 09:59:24

@Quocvu 

 

Plug the ethernet cable in the other ethernet port (on satellite Deco).

If the issue persists then change the cable (a quality Cat 5E/6 cable is required).

This usually happens when the negotiated speed is not 1000mbps, but only 100mbps.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 507

Replies: 1

Related Articles
AX55 cap speed 100Mbps alltime
363 0
100mbs cap
198 0
Slave Deco M4R keeps disconnecting from main Deco M4R
673 0
SPEED CAP at 100MBPS in Router Mode Only!
576 0
slave Deco M4R does not connect via cable but only via wifi
452 1
Archer C80 WAN cap 100mbps problem
657 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.