Trade in - mr600 v1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
Whats the difference between the mr600 v1 and v2.
Is there a trade in program that customers of the v1 can use to get the benefits of the v2 version?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, the official firmware of V2 has supported band selection already, for the V1, the official firmware is on the way;
And Archer MR600 V2 supported band aggregation for B1+B3, but not supported IPsec VPN anymore;
Thank you.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@TP-Link Good evening,
I recently bought your Archer MR600 where for the first two days it connected to 4G +, unfortunately after moving it, he no longer wanted to connect to 4G +, by removing the sim and trying it on the smartphone, 4G + works fine, looking for a solution and if had been previously I searched in your forums and online in general, then I downloaded the firmware available on your official download portal on the TPLINK site but once I go to install it it tells me that the version is not the same despite being careful of download the V2, both in the Firmware section of the router and in the ISP. Unfortunately, I was unable to speak to a technical support agent.
Hardware Version: Archer MR600 v2 00000002
Firmware version: 1.4.0.0.9.1 v0001.0 Build 210727 REL 33453n
Thanks
- Copy Link
- Report Inappropriate Content
Hi, your current firmware version already supports manual band selection and there is no need to update other beta firmware.
How to select 4G band manually on the web interface of LTE Gateway Routers?
Currently. if it is not on 4G LTE mode, what is the network type now?
If it is WCDMA, you could have a look at this link:
No connection in 4g after reboot
Thank you very much.
- Copy Link
- Report Inappropriate Content
Check out the spec difference for both AU models here https://www.tp-link.com/au/home-networking/3g-4g-router/archer-mr600/
Some info on Antennas if you are interested too https://community.tp-link.com/en/home/forum/topic/272342
John vk3hjq
- Copy Link
- Report Inappropriate Content
I would also like to have my MR600 v1 replaced with v2.
v1 seem to have hardware issues that can not be resolved by tp link support.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1672
Replies: 6
Voters 0
No one has voted for it yet.