Home Network Community > All Threads > Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
< All Threads

Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
2021-02-18 15:11:15
Model: Archer C6  
Hardware Version: V2
Firmware Version: 1.1.7

I'm trying to pass my Ipv6 connectivity to my wireless router, but I can't make the Archer C6 recognize my dynamic IP. When I connect my PC via Ethernet directly to the ISP's modem, I'm able to use IPv6 normally.

However, If I connect my PC to the router's LAN ports, it appears that my router can't locate my v6 address. I've already tried setting up Dynamically and also manually, with no success.

My provider uses IPv6 with DHCPv6

Can someone help me with this?

  0      
 
  0      
 
#1
Options
1 Reply
Re:Can't use Ipv6 on router. Works perfectly when connected directly on ISP's modem
2021-02-22 03:29:50

@Diucke 


Kindly refer to the below guide to configure the IPv6 on the C6 router again:

https://www.tp-link.com/support/faq/1525/


If the connection still fails, please confirm again if the IPv6 type is Dynamic or PPPoE with your ISP. BTW, who is your ISP?


What is your network topology, is it ISP modem--C6? Is the IPv4 connection on the C6 good or not? What is the WAN IP address of it?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE550 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, ECO Mode, and More Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 531

Replies: 1

Related Articles
Can't use my router as access point.
1848 1
AX3000: setting up to use IPv6 behind an ISP router
3728 0
I can't use my router in this app
412 0
Why my Range Extender Works perfectly for 1 minute then stops?
2549 0
RE200 LIMITED internet on NOTEBOOK, cell works perfectly
695 0
Can't connect Two onemesh router
176 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.