Home Network Community > All Threads > I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware
< All Threads

I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware
I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware
2020-10-18 09:20:05 - last edited 2020-10-19 05:25:52
Model: TD-W8970  
Hardware Version: V1
Firmware Version: v1.2

I bought a used tp-link w8970 router and it already using OpenWRT. I bricked it when i was trying to restore the original firmware on it but now the wifi LED is no more showing when i switch it on and there is also no wifi. Only power light turn on but nothing else. When i put LAN cable to LAN1 port nothing change. The wifi also can't be detected. I already try to connect using TFTP 64 and reseting it, but no luck. Here is the picture of my router : https://ibb.co/30gWyqz 

 

Thank you

  0      
 
  0      
 
#1
Options
2 Reply
Re:I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware
2020-10-22 06:36:21

@Ariflorina 

Good day,

Thank you very much for your time and patience.

Sorry for the delay.

Have you tried to factory reset the TD-W8970 before to see if that helped?

If not, I am afraid that there is no more suggestions.

Since you just bought it, you could try to contact the shop retailers to get it replaced first.

 

Thanks a lot.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:I bricked my Tp-Link W8970 while trying to change the firmware from OpenWRT to the original Firmware
2020-10-26 13:15:59

Hi @Sunshine, thank you for your reply. I already tried reseting several times. No luck. Nothing change, and no respond.

 

Thank you 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1225

Replies: 2

Related Articles
Bricked TD-W8970
1189 0
TP-Link TD-W8970 Chip Erased
1204 0
TD-W8970
472 0
Accidentaly bricked my TP-Link W8970 Router
1135 0
Range extending using TD-W8970 connected via TL-PA4010 / TL-WPA4220
967 0
TD-W8970 freezes requently
513 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.