Home Network Community > All Threads > Wireless backhaul
< All Threads

Wireless backhaul

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireless backhaul

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireless backhaul
Wireless backhaul
2020-09-24 12:35:53
Model: Deco M9 Plus  
Hardware Version: V1
Firmware Version: 1.42

I have setup the deco M9, and reviewed the backhaul connections.

 

Despite the position applied, both of the slave decos seem to only connect to the main over wireless.  I am configured in access point.

 

I had an expectation based on documentation, that the units would connect to the strongest closet unit regardless of slave vs master in a serial configuration, am I mis-reading the documentation ?

 

Regards

 

Fuzzybear.

 

 

  0      
 
  0      
 
#1
Options
1 Reply
Re:Wireless backhaul
2020-09-24 21:29:38

@Fuzzybear 

 

Your Decos should work without problem with a wired backhaul when in AP mode. Mine do.

 

Could you describe your topology / layout.

 

I would either wire your Decos back into the same switch as your router, or directly back to the router.

 

Your router will need to be set as your  your DHCP server so that it can allocate an IP Address to your Deco units.

 

I would ensure that if you are using a smart switch that you have disabled the VLAN on the ports that the Deco and router are connected. Guest Wifi no longer uses the Vlan 591 when in AP mode.

 

 

-- Deco X50-POE user
  2  
  2  
#2
Options

Information

Helpful: 0

Views: 659

Replies: 1

Related Articles
Wireless backhaul "in line topology"
2063 0
RE450 Wireless Backhaul
725 0
WiFi Network / Ethernet Backhaul
647 0
Deco M9 Plus Wireless Backhaul with Wifi-6 capable Main?
2546 0
Wireless backhaul causing Spanning Tree to block ports and cause outages
257 1
Mixing Wire and Wireless Backhaul
737 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.