Seamless setup of Archer AX3000 with Deco P9

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Seamless setup of Archer AX3000 with Deco P9

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Seamless setup of Archer AX3000 with Deco P9
Seamless setup of Archer AX3000 with Deco P9
2020-09-01 16:38:06 - last edited 2020-09-02 03:27:14
Model: Archer AX3000  
Hardware Version: V1
Firmware Version: 1.0.4 Build 20200426 rel.69563(5553)

Apologies if this is noted someplace else in the forum, I was unable to find it.

 

I'm curious if my Archer AX3000 (router mode) and my Deco P9 (AP mode) systems can be set up so they all allow a device to seamlessly crossover when that devices changes zones.   

 

Right now I have the P9's set so they do seamlessly allow the device to crossover and keep the best signal possible, but when the device cross's over to the Archer AX3000's zone, the device has to be manually switched to the AX3000 and vice versa when it crosses from the AX3000 back into the P9 zones. 

 

Drak

  0      
  0      
#1
Options
1 Accepted Solution
Re:Seamless setup of Archer AX3000 with Deco P9-Solution
2020-09-02 03:26:23 - last edited 2020-09-02 03:27:14

@Drakcon 

 

Hi,

 

Sorry that the Deco can't build a mesh network with those non-Deco devices. The Deco Mesh is the technology only used on TP-Link Deco products for the Mesh network.

 

Good days.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Seamless setup of Archer AX3000 with Deco P9-Solution
2020-09-02 03:26:23 - last edited 2020-09-02 03:27:14

@Drakcon 

 

Hi,

 

Sorry that the Deco can't build a mesh network with those non-Deco devices. The Deco Mesh is the technology only used on TP-Link Deco products for the Mesh network.

 

Good days.

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 1028

Replies: 1

Related Articles