Home

Forums

Stories

Knowledge Base

Home Network Community > All Threads > Wireless radio transmision when wireless network is off

< All Threads

Wireless radio transmision when wireless network is off

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireless radio transmision when wireless network is off

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

kicho_c6

2020-08-06 11:12:18 - last edited 2020-08-07 05:29:59

Posts: 3

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-08-05

Wireless radio transmision when wireless network is off

2020-08-06 11:12:18 - last edited 2020-08-07 05:29:59

Model: Archer C6

Hardware Version: V2

Firmware Version: 1.3.5

I recently brought C6 V2 EU and I am facing problem with “turning off” wireless.

When is set to off , the wireless network is transmit signal repetitive for few seconds without SSID and on full power. I have set transmission power to low, and it is low when the wireless is on. But when it is off, transmissions are with high power. 2.4 Ghz radio transmits for 30-40 seconds on every 2 minutes. 5 Ghz transmits for 10 seconds on every minute. Tested on firmware versions 1.3.5 and 1.3.7

I did not check the original version, I was hurry to have “wireless schedule” …. Big mistake…

Reading forum for solution, it seams this behavior come with OneMesh.

Any help with this?

Can somebody provide me an old firmware, 1.0.x or 1.1.x

1 Accepted Solution

Kevin_Z

2020-08-07 05:29:45 - last edited 2020-08-07 05:29:59

Posts: 21782

Helpful: 5161

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:Wireless radio transmision when wireless network is off-Solution

2020-08-07 05:29:45 - last edited 2020-08-07 05:29:59

@kicho_c6

Hello,

The hidden wireless network is used to build up the mesh wireless network system, which we call it Onemesh. For more details, please refer to the below article, which will help answer it:
https://community.tp-link.com/en/home/stories/detail/728

The good news is that we already have the plan to add an Onemesh on/off switch on the firmware, which will allow you to turn it off manually. This will take some time, however, we hope you could wait patiently.

Good days.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Information

Helpful: 0

Replies: 2

Wireless radio transmision when wireless network is off

Wireless radio transmision when wireless network is off

Information

Voters 0

Tags