Adding passthrough to TL-WPA4220
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Adding passthrough to TL-WPA4220
Hello
can I install a TL-WPA4220KIT and then add to it a passthrough powerline adaptor like TL-WPA8630P?
I need a passthrough adaptor in the room I am extending to, and I cannot directly install a TL-WPA8630PKIT because the TL-PA8010P element is too big for where it needs to go. By contrast, the TL-PA4010 element of the TL-WPA4220KIT is much smaller and would fit easily. I don't mind it not having a passthrough socket in that room.
Or if there ar eany other solutions? I am not too concerned about speed.
Thanks!
1 Accepted Solution
Re:Adding passthrough to TL-WPA4220
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection
Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul
If you found a post or response helpful, please click Helpful (arrow pointing upward icon).
If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.