[Deco M5] Manually configure LAN IP resets on reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

[Deco M5] Manually configure LAN IP resets on reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

sameesbn

2019-06-24 04:45:08 - last edited 2019-07-03 02:52:46

Posts: 3

Helpful: 3

Solutions: 0

Stories: 0

Registered: 2019-06-24

[Deco M5] Manually configure LAN IP resets on reboot

2019-06-24 04:45:08 - last edited 2019-07-03 02:52:46

Model: Deco M5

Hardware Version:

Firmware Version:

I have serveral devices on my existing network, with a server using the 192.168.1.1 as the IP address. As a result I could not just use 192.168.1.1 as the IP address for the Deco M5 network. Therefore, I configured the LAN IP on the M5 network to 192.168.1.254 and everything worked fine until the Deco M5 was rebooted. Upon reboot I noticed that the LAN IP on the Deco M5 changed to 192.168.1.1 and as a result there was a IP conflict with the server and I end up with a non-functioning network. How do I make the M5 stick to the IP address I configured it to use?

I can go and make changes to the IP addresses of other devices on the network and make it work, but this would required a lot of work.

1 Accepted Solution

Kevin_Z

2019-06-24 11:03:19 - last edited 2019-07-03 02:52:46

Posts: 21782

Helpful: 5160

Solutions: 2575

Stories: 21

Registered: 2018-12-24

Re:[Deco M5] Manually configure LAN IP resets on reboot-Solution

2019-06-24 11:03:19 - last edited 2019-07-03 02:52:46

Hi,

please change the WAN DNS and make it not in the same network segment as the LAN IP.

How to change WAN DNS: https://www.tp-link.com/support/faq/1855/

After that, please test whether it works.

Any updates, please let us know.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router Archer BE800 New Firmware Added Support for EasyMesh in AP Mode, DoH&DoT, and 3-Band MLO Connection Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Information

Helpful: 0

Replies: 3

[Deco M5] Manually configure LAN IP resets on reboot

[Deco M5] Manually configure LAN IP resets on reboot

Information

Voters 0

Tags