TL-PA7020P Shows as 'UNKNOWN'
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-PA7020P Shows as 'UNKNOWN'
Model :
Hardware Version :
Firmware Version :
ISP :
Hi,
I bought a couple of starter packs which resulted in me having 4 of the TL-PA7020P model.
Three of them are working fine but the fourth is exhibiting some strange behaviour and i'm hoping someone here might have some clues as to how to fix it.
Firstly, let me say that right off the bat I had problems getting them to pair using just the pair button. In the end I got it working by firstly upgrading the firmware on each unit and then using the tpPLC utility to add them to the environment. This works fine; please note that the one unit I have a problem with is one that has not yet had it's firmware updated.
The issue I face is that when I connect this particular unit to a socket and power it on it will appear in the tpPLC utility but it shows as 'UNKNOWN' and the only options available are to rename it or to remove it from the network. The name change persists as expected. The removal does remove it from the network but after a short period it reappears in the list.
I have also tried resetting the unit by holding it down for 15 seconds but that doesn't seem to do anything either.
Has anyone got any suggestions on this please?
Thanks
Pete
Hardware Version :
Firmware Version :
ISP :
Hi,
I bought a couple of starter packs which resulted in me having 4 of the TL-PA7020P model.
Three of them are working fine but the fourth is exhibiting some strange behaviour and i'm hoping someone here might have some clues as to how to fix it.
Firstly, let me say that right off the bat I had problems getting them to pair using just the pair button. In the end I got it working by firstly upgrading the firmware on each unit and then using the tpPLC utility to add them to the environment. This works fine; please note that the one unit I have a problem with is one that has not yet had it's firmware updated.
The issue I face is that when I connect this particular unit to a socket and power it on it will appear in the tpPLC utility but it shows as 'UNKNOWN' and the only options available are to rename it or to remove it from the network. The name change persists as expected. The removal does remove it from the network but after a short period it reappears in the list.
I have also tried resetting the unit by holding it down for 15 seconds but that doesn't seem to do anything either.
Has anyone got any suggestions on this please?
Thanks
Pete
