Home Network Community > All Threads > Network map is wrong
< All Threads

Network map is wrong

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Network map is wrong

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Network map is wrong
Network map is wrong
2018-03-20 21:53:33
Model :

Hardware Version :

Firmware Version :

ISP :

When using the windows TPLink Powerline utility, the arrows on the network map are pointing in the wrong direction - does this matter? Also for some reason one adaptor is showing a MUCH lower rate than the other despite the fact they were plugged in side by side in the power outlet at the time?
  0      
 
  0      
 
#1
Options
2 Reply
Re:Network map is wrong
2018-03-22 15:02:41
wrong direction? usually when you click one unit on the utility, it will show the direction from that unit to all the other units, is that what you sees?
If a specific unit has a low speed, you may also try to plug it in other wall socket or exchange it with other units
  0  
  0  
#2
Options
Re:Network map is wrong
2018-03-22 19:01:40
Low powerline speeds are commonly displayed for adapters that are in standby/powersave mode.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 786

Replies: 2

Related Articles
Clear wrong Connected Clients entries on Network Map
286 0
see network map on wierd
392 0
Network MAP
534 0
Mesh device number wrong in Network Map (Archer AX55)
588 0
Network map for Deco
3891 0
Clients not showing up on network map (AX50 & AX20)
4300 3
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.