TP-LINK TL-WR740N working in a bridge mode.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-LINK TL-WR740N working in a bridge mode.
Model :
Hardware Version :
Firmware Version :
ISP :
Hi, I have wireless network in my home but in one room signal is very low so I want to use TL-WR740N as a bridge. There is no possibility to choose a wire solution. I've already change the OS on the router to dd-wrt. I've configured it in a client bridge mode but when I connect it to my pc via ethernet cable I've no network access. I suppose there can be an IP addresses problem. My primary router has IP 192.168.1.254, tp-link address i've set as 192.168.1.201. DHCP is enabled only on my primary router. And now, pc ip address (from dhcp) is 192.168.102.211 (very strange) and when I check on the primary router which devices are connected the ip address is 1.1.1.1. What can be a reason of this problem?
Hardware Version :
Firmware Version :
ISP :
Hi, I have wireless network in my home but in one room signal is very low so I want to use TL-WR740N as a bridge. There is no possibility to choose a wire solution. I've already change the OS on the router to dd-wrt. I've configured it in a client bridge mode but when I connect it to my pc via ethernet cable I've no network access. I suppose there can be an IP addresses problem. My primary router has IP 192.168.1.254, tp-link address i've set as 192.168.1.201. DHCP is enabled only on my primary router. And now, pc ip address (from dhcp) is 192.168.102.211 (very strange) and when I check on the primary router which devices are connected the ip address is 1.1.1.1. What can be a reason of this problem?
