Unable to connect to the Internet
When you first set up Deco, after going through the whole setup process on the Deco APP, sometimes it might end with an Error: Unable to connect to the Internet.
Normally, when you got this error, the LED on the main Deco will also turn red.
Here, we will help you to fix this issue.
1. Please Tap “Skip This Step” on the bottom of the error page.
2. Then make sure the smartphone is connected to the Wi-Fi you just created and go back to Deco APP>More>Advanced>IPV4 to check whether there is a valid IP address here.
- If the IP address is 0.0.0.0, it is very likely that you might choose the wrong internet connection type. Please check with the internet service provider whether Dynamic IP or PPPOE is the correct one for you.
- If the IP address is not 0.0.0.0, please refer to this link to change the DNS server on the Deco: How to change DNS server settings on my Deco
3. After changing the DNS, if the LED is still red and also no internet service is available, please connect a computer to the modem directly, and check whether the computer has internet access.
- If the computer doesn't have internet as well, it is also suggested to check with ISP to see whether there is an internet outage.
- If the computer does work well, please refer to this link to manually clone the MAC address of the PC on the Deco: How to Configure MAC Clone on Deco if Deco fails to connect to the internet
After the above troubleshooting, if you still have any issues, please start a new thread and provide us with more details.
I forgot my Wi-fi password of TP LINK router
Great! the troubleshoting steps are simple and straight forward. Darn well
I have a Deco instalation with 4 Access points working properly.
But in the app to control that instalations in my mobile it alwais appears the screen of "firmware updated is required", although I have done that many times with a final result that all devices are updated and the system works propertly.
But immediatly that screen appears and there is no other thing you can do in the app.
Another question is how to know to which access point I am (I have 4) connected at any time.
Mi yicam dafa 1080p
How can i do a block for anyone??
F
How to configure a new deco m4 to a network of two m4?
they are some people steal my wifi network
I need to be able to change channels on both 2.4Ghz and 5Ghz band where my Router TP-Link M4R deco) its always operate by overlapping strongest signal in the neighbours appartment which is on 2nd floor! In my situation frequency spectrum is almost empty besides this spefic Ch I me and my neihgbour router use.