Model :

Hardware Version :

Firmware Version :

ISP :

Hello All,
I have recently bought an Archer VR600 and am having an issue with the DHCP settings. After a while of being on, I'm unable to obtain DHCP addresses for new clients until I reset the router.

I had this on my previous router, and have taken the following steps, but still get the same issue:
I previous had an issue with a couple of devices (one being an Apple TV), so those now have static IP addresses
[*]I reduced the DHCP lease to 120 minutes
[*]Firmware is fully up to date
Despite this, I still seem to be running out of addresses. After a reboot, a new device is still getting a remarkably high IP address. I'm assigning 192.168.1.20 to 192.168.1.199, and new devices are getting addresses over 150.

Any advice on settings to try or other diagnostics that might be helpful?

Thanks,
Nick