Archer VR900 disconnects from WAN when connecting a new device via WiFi
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR900 disconnects from WAN when connecting a new device via WiFi
Model : Archer VR900
Hardware Version : v1 00000000
Firmware Version : 0.9.1 1.4 v004c.0 Build 160316 Rel.44905n
Hello, everyone.
I have a problem with my Archer VR900 Router. When connecting a device to the WiFi (it could be a tablet or a smartphone), I get disconnected from the WAN, and it needs several minutes for the connection to return.
While experiencing the problem, if I disconnect the newly connected device the WAN connection immediately returns.
Note that I have several devices connected via WiFI and ethernet cable, the problem I'm experiencing doesn't occur with a specific device. The DHCP is active, and I have not set any address reservation.
Right now I have activated only the 2.4GHz wireless network, but the disconnections occurs even in dual-band mode.
Hardware Version : v1 00000000
Firmware Version : 0.9.1 1.4 v004c.0 Build 160316 Rel.44905n
Hello, everyone.
I have a problem with my Archer VR900 Router. When connecting a device to the WiFi (it could be a tablet or a smartphone), I get disconnected from the WAN, and it needs several minutes for the connection to return.
While experiencing the problem, if I disconnect the newly connected device the WAN connection immediately returns.
Note that I have several devices connected via WiFI and ethernet cable, the problem I'm experiencing doesn't occur with a specific device. The DHCP is active, and I have not set any address reservation.
Right now I have activated only the 2.4GHz wireless network, but the disconnections occurs even in dual-band mode.
