Archer C20 is not connect automatically to the Internet
Hardware Version :
Firmware Version :
ISP :
Archer C20 is not connected to the Internet
After switching on /restarting WiFI router does not have internet access.. For internet access, every time I should click on Disconnect button and then Connect button from WAN setting. Internet access never connect directly without these process.. It is very irritating to do again and again when no internet access...
Firmware Version:0.9.1 2.1 v0044.0 Build 151120 Rel.35051n
[B]Hardware Version:Archer C20 v1 00000000
[/B]
Model : Archer C20
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Secondary Connection - Disabled
Connection Mode - Always On
Max Idle Time - 0
Authentication Type - AUTO_AUTH
Regards.
- Copy Link
- Report Inappropriate Content
As for the Connection Mode, you can select On Demand and set the value as 0.
- Copy Link
- Report Inappropriate Content
radhx wrote
Check with the following setting for WAN -
Secondary Connection - Disabled
Connection Mode - Always On
Max Idle Time - 0
Authentication Type - AUTO_AUTH
Regards.
We can't able to change Max Ideal Time as 0 when Connection Mode as "Always On". So, I made connection Mode as "Manual" and then change the value of Max Ideal as 0 then after I am facing same problem....
- Copy Link
- Report Inappropriate Content
tplink wrote
May I know your internet connection type? Is it Dynamic IP or PPPoE? How often does it drop the internet?
As for the Connection Mode, you can select On Demand and set the value as 0.
Connection type: PPPoE
I have changed Connection Mode as "On Demand" as well as set the value as 0 after that also it is not helping out me. :(
Before I used Digisol single anteena router and it is working fine.
The service provider that is Net9online by Hathwat said that in TP-Link dual band having some problem . Problem means - either you are switched off the router or restart the router you should goes to setting and click on "Connect" button everytime.. Please help me for this issue..
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Secondary Connection - Disabled
Connection Mode - Connect on demand
Max Idle Time - 0
Authentication Type - AUTO_AUTH
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
if the above setting haven't resolved the issue then upgrade the firmware and reboot the router
click the below url to download the firmware.
https://drive.google.com/open?id=0B88FTY6zbUGUSGFjZURlLTgyVVU
- Copy Link
- Report Inappropriate Content
Resolved !!
Finally, I am relieved of connecting and disconnecting the router manually from the WAN section.
Steps to Resolve:
1. Download the new firmware from the link provided by @kk99226 and upgrade the router firmware. ( Please read the firmware upgrade steps and notes from the official docs before upgrading )
2. Perform these steps:
Secondary Connection - Disabled
Connection Mode - Connect on demand
Max Idle Time - 0
Authentication Type - AUTO_AUTH
3. Reboot/Restart the router and that's it.
Now the router would connect to the internet automatically on every boot.
[ Warning: After upgrading the firmware the router was out of configuration ie The router was completely factory reset and I had to manually re-configure it again ]
- Copy Link
- Report Inappropriate Content
The drive link is not working. Can you look into this if possible?
I am having the exact same problem even if I have exchanged it twice !
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 4061
Replies: 9
Voters 0
No one has voted for it yet.