Archer VR600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR600
Archer VR600
2016-09-03 04:49:07
Model :

Hardware Version :

Firmware Version :

ISP :

My new Archer VR600 switch off the 2.4GHz radio automatically after few minutes of use and need to be rebooted to switch on it again. Only the 5GHz radio is working properly.

Could you help me

The FW of the router is 0.1.0 0.9.1 v0057.0 Build 160217 Rel.53237n
and the HW version is Archer VR600 v1 00000000

Thank you in advance for your support

Regards

Francesco
  0      
  0      
#1
Options
2 Reply
Same problem here as well
2017-05-27 19:47:06

FrancescoChino wrote

Model :

Hardware Version :

Firmware Version :

ISP :

My new Archer VR600 switch off the 2.4GHz radio automatically after few minutes of use and need to be rebooted to switch on it again. Only the 5GHz radio is working properly.

Could you help me

The FW of the router is 0.1.0 0.9.1 v0057.0 Build 160217 Rel.53237n
and the HW version is Archer VR600 v1 00000000

Thank you in advance for your support

Regards

Francesco


Hello Francesco, I had the same problem, only in my case I needed to reboot the modem ~4 times a day even after the firmware update. In the end, I took it back to the store that I bought it from and they gave me a new one. The new had the same problem right out of the box, again I updated the firmware, I reboot it and so far it has not lost the 2,4Ghz frequency for about 48 hours. It is very disappointing though...
If you found some other solution, please post.
Thanks, Ilias
  0  
  0  
#2
Options
Re:Archer VR600
2017-08-18 07:06:03
I had the same problem with a VR400 and the 5 GHz radio - it was unusable. I took it back for refund. I believe this symptom is a hardware fault.
  0  
  0  
#3
Options