Model : TL-WDR4300

Hardware Version : V1

Firmware Version : 0.9.1 1.4 v004c.0 Build 160316 Rel.44905n

ISP :

Hi all,

i'm trying to configure the wake on lan on my HP Prolian Server, below the configuration steps:

1. Enabled WOL option into the LAN Board Bios
2. Enabled WOL options into the Windows Driver (all settings about WOL, Magic Packet, PME, etc)
3. Enabled port forwarding into the VR900 (UDP port 9) to the IP address referred to the HP Server
4. Enabled the address reservation for the MAC Address concerning the HP Lan Board

Problem: the WOL works fine only few minutes after the shutdown, after which i have to use the switch directly on the HP Server.

Where i wrong?


Thank you
Vittorio