How to disable Client-Mac-Adress changes on TL-WA850RE V2.0?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to disable Client-Mac-Adress changes on TL-WA850RE V2.0?
Model : TL-WA830RE
Hardware Version : V2
Firmware Version : 1.0.0 Build 20151228 Rel. 63247
ISP :
Hello.
I'm using a TL-WA850RE V2.0 (1.0.0 Build 20151228 Rel. 63247) to extend my WiFi.
I found out, that any device who try to get a ip over this extender, have a manipulated MAC beginning with 62:e3:.......
The problem are, I using DHCP to give all devices in my network a fixed IP.
The fixed IPs are needed to access some ports from LAN and WAN. (FTP, SCP, Web and so on).
Now I need often to change my IP in my FTP-Client. Somestimes a device switch between the networks and I need to restart this filetransfer with the other IP again. :mad:
I use also a TP-Link TL-WR841N to extend the network in an other area. But there are no MAC-address-changes.
How I can disable this curious and stressful behavior?
PS:
All my SSIDs are different. My (very sentient) WiFI-Radio (dnt ipdio) fail always, if I try to connect with any TP-AP. Very courios.
Hardware Version : V2
Firmware Version : 1.0.0 Build 20151228 Rel. 63247
ISP :
Hello.
I'm using a TL-WA850RE V2.0 (1.0.0 Build 20151228 Rel. 63247) to extend my WiFi.
I found out, that any device who try to get a ip over this extender, have a manipulated MAC beginning with 62:e3:.......
The problem are, I using DHCP to give all devices in my network a fixed IP.
The fixed IPs are needed to access some ports from LAN and WAN. (FTP, SCP, Web and so on).
Now I need often to change my IP in my FTP-Client. Somestimes a device switch between the networks and I need to restart this filetransfer with the other IP again. :mad:
I use also a TP-Link TL-WR841N to extend the network in an other area. But there are no MAC-address-changes.
How I can disable this curious and stressful behavior?
PS:
All my SSIDs are different. My (very sentient) WiFI-Radio (dnt ipdio) fail always, if I try to connect with any TP-AP. Very courios.