Archer VR900 - stop IPSec process?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR900 - stop IPSec process?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR900 - stop IPSec process?
Archer VR900 - stop IPSec process?
2015-12-24 17:35:19
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hi there,

I am trying to troubleshoot an IPSec issue where an tunnel is created through the router to an internal device. IPSec Passthrough is enabled, but the device cannot negotiate.

There are no tunnels defined on the router at all, and the device has been configured as DMZ.

Another forum suggested it was possible the IPSec daemon on the router was not doing true passthrough and maybe intercepting some elements of the conversation. So, is it possible via command line to turn off the IPSec daemon completely so that I can eliminate this possibility?

Thanks
Stuart
  0      
  0      
#1
Options
1 Reply
Re:Archer VR900 - stop IPSec process?
2015-12-28 15:26:40
Hi Stuart,
Are you setting IPSec VPN correctly?
Is the tunnel status up on the manage page?
If the status is up but the device can't negotiate,you can try to disable the firewall and try again.
  0  
  0  
#2
Options