Archer D7 as AP and DHCP relay agent
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer D7 as AP and DHCP relay agent
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi, I used AD7 as a main router, but recently I bought Ubiquiti ERL and decided to do DHCP on it. Archer will work only as an access point and DHCP relay agent. I chose 192.168.10.x pool addresses, 1 for Ubi router, 2 for Archer, next numbers dynamically for the rest.
I'm not sure how to configure it properly. Can someone tell me if I'm right?
1. Network > WAN Interface > Connection Type: Static > IP: archer, gateway: ubiquiti
Or maybe dynamic mode will configure it all itself and well, it's dynamic on Ubi, just reserved .2 for AP?
2. Advanced > disable NAT
3. LAN > DHCP relay
Is it enough?
Hardware Version : Not Clear
Firmware Version :
ISP :
Hi, I used AD7 as a main router, but recently I bought Ubiquiti ERL and decided to do DHCP on it. Archer will work only as an access point and DHCP relay agent. I chose 192.168.10.x pool addresses, 1 for Ubi router, 2 for Archer, next numbers dynamically for the rest.
I'm not sure how to configure it properly. Can someone tell me if I'm right?
1. Network > WAN Interface > Connection Type: Static > IP: archer, gateway: ubiquiti
Or maybe dynamic mode will configure it all itself and well, it's dynamic on Ubi, just reserved .2 for AP?
2. Advanced > disable NAT
3. LAN > DHCP relay
Is it enough?