Disabling NAT in TL-WR940N
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hardware Version : V1
Firmware Version : 3.13.9 Build 120201 Rel.54965n
ISP :
Hello,
I can't find the option to disable NAT at TL-WR940N, is this possible? (I don't want to disable DHCP)
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I have the same issue. So we cannot disable NAT? I have FW acting as the WAN gateway, where I got the TL-WR940N to serve as the LAN wireless in a trust zone.
I wanted to have all wireless users receiving IP address via DHCP from the Tp_link and whole traffic be Natted only at my FW Gateway. However, even with the TP-link firewall disabled, it seems I cannot turn off NAT on it.
In the Working Mode section, seems that it requires the Access Point mode, but it is not working.
Could you confirm this? I want the TP-link acting as simple wireless concentrator and router (NO NAT). The issue I have is that all devices reaches the FW with the WAN TP-link IP address, so unless deploying User-ID or any other sofisticated technique, it is difficult to track the session per user in the Firewall Gateway.
Could you please clarify this to me?
Thanks a lot
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2414
Replies: 3
Voters 0
No one has voted for it yet.