PPPOE connection static IPv4 address
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
PPPOE connection static IPv4 address
Region : Australia
Model : TD-8816
Hardware Version : V8
Firmware Version : 8.0.0 Build 140311 Rel.29246
ISP :
on the interface page near the bottom it has IPv4 address, dynamic or static, i've already setup a pppoe connection with dynamic, how do i make a static one?, i've tried putting something like IP: 192.168.1.30, subnet mask: 255.255.255.255, default gateway: 192.168.1.1, but then i get a message that says 'lan ip and wan ip cannot be set in the same network', how do i setup static IPv4 address?
Model : TD-8816
Hardware Version : V8
Firmware Version : 8.0.0 Build 140311 Rel.29246
ISP :
on the interface page near the bottom it has IPv4 address, dynamic or static, i've already setup a pppoe connection with dynamic, how do i make a static one?, i've tried putting something like IP: 192.168.1.30, subnet mask: 255.255.255.255, default gateway: 192.168.1.1, but then i get a message that says 'lan ip and wan ip cannot be set in the same network', how do i setup static IPv4 address?
