Archer D7 - port forwarding
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer D7 - port forwarding
Region : Italy
Model : TD-W8968
Hardware Version : V1
Firmware Version : 0.9.1 0.9 v002d.0 Build 141014 Rel.51158n
ISP : Tiscali
Hello,
I have an archer D7. On the router are currently active:
SPI firewall
Firewall standard
On the firewall I set as a default rule DENY (Deny the packets not specified by any filtering rules to passthrough this device).
I then created a rule to allow all traffic outbound from my LAN to the WAN. Everything works properly.
Now I need to access from outside (smartphone, office) Webcam IP in my network lan(webcam has a static address). So I created:
- A virtual server (under the section forwarding) to enable the port that meets the Webcam IP (snapshot 1).
- An item under LAN HOST where I entered the static IP of the webcam in my LAN plus the port used (snapshot 2).
- Rule on the firewall where I enable all incoming traffic to the webcam (snapshot 3).
PROBLEM:
If I disable the firewall works all regularly. If I enable the firewall the webcam is unreachable.
I did several tests trying to declare in LAN Host only the 'ip of the device,
but without success. When activated, the firewall stops working.
Do you have any idea or experience about?
Thanks
Model : TD-W8968
Hardware Version : V1
Firmware Version : 0.9.1 0.9 v002d.0 Build 141014 Rel.51158n
ISP : Tiscali
Hello,
I have an archer D7. On the router are currently active:
SPI firewall
Firewall standard
On the firewall I set as a default rule DENY (Deny the packets not specified by any filtering rules to passthrough this device).
I then created a rule to allow all traffic outbound from my LAN to the WAN. Everything works properly.
Now I need to access from outside (smartphone, office) Webcam IP in my network lan(webcam has a static address). So I created:
- A virtual server (under the section forwarding) to enable the port that meets the Webcam IP (snapshot 1).
- An item under LAN HOST where I entered the static IP of the webcam in my LAN plus the port used (snapshot 2).
- Rule on the firewall where I enable all incoming traffic to the webcam (snapshot 3).
PROBLEM:
If I disable the firewall works all regularly. If I enable the firewall the webcam is unreachable.
I did several tests trying to declare in LAN Host only the 'ip of the device,
but without success. When activated, the firewall stops working.
Do you have any idea or experience about?
Thanks