Early Access Deco M4_V1/V2_1.7.0 Official Ready for Test!
This Article applied to
Deco M4_V1/V2_1.6.5
Firmware Modifications:
- Supported customizing Satellite Deco signal source.
- Supported customizing Client connection preferences.
- Added Reboot Schedule.
- Added NO-IP and DynDNS.
- Supported setting Effective Time and Bandwidth Limit for guest network.
- Added Smart DHCP switch under Access Point mode.
- Added Static Route.
- Supported customizing MTU size.
- Added IoT network.
- Added QoS on/off toggle.
Download Link:
| Deco M4_V1/V2(SG) |
1.7.0_build_20250228_ Pre Release | Newly updated to the 1.8.0 Platform |
| Deco M4_V1/V2 (US/AU/UK/B4/JP/TW/EG) |
1.7.0_build_20250228_Pre Release |
Update notice:
1. How to update the firmware via web UI.
2. The firmware downgrade(back to the official 1.6.5 version) needs to be implemented via firmware recovery.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@josp11 Finally your issue has been resolved. Now your guests will consume your whole internet speed 🤣😂
- Copy Link
- Report Inappropriate Content
No, because now I can limit guest network bandwidth 😁
Just to clarify, my problem was solved in a previous build of firmware 1.7, after TP-Link support provided remote assistance. I only was afraid that this pre-release build would bring the issue back. Fortunately, that didn't happen 🙂
- Copy Link
- Report Inappropriate Content
@josp11 That's nice. Good for you
- Copy Link
- Report Inappropriate Content
@David-TP Deco M4 has the same hardware as Deco P9 with exception of PLC . Do you have plans to release Deco P9 firmware with the similar functionalty as for M4?
- Copy Link
- Report Inappropriate Content
Hi, I'm afraid that there hasn't been any updated news about Deco P9 yet.
There's a slight chance that Deco P9 might get a similar firmware upgrade.
Best regards.
- Copy Link
- Report Inappropriate Content
SayeemAhmed wrote
@David-TP Will I automatically receive this update on my already installed 1.7.0 beta version or do I have to install it manually...?
@SayeemAhmed
- Copy Link
- Report Inappropriate Content
@admin512 You have to install it manually by Web UI because this Early Access is a Official firmware but in testing mode which is much better than the Beta firmware and when the Stable firmware will come so you will get it on Deco App
- Copy Link
- Report Inappropriate Content
Information
Helpful: 5
Views: 3206
Replies: 57
Voters 3
