Pairing Linksys PLE400 with TP-Link TL-PA201
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Pairing Linksys PLE400 with TP-Link TL-PA201
Region : UnitedKingdom
Model : TL-PA2010
Hardware Version : V1
Firmware Version :
ISP :
I had a pair of TP-Link TL-PA201homeplugs set up on my home network. These helped extend network to a wired device in another room.
I bought a set of Linksys PLE400 and PLW400 so I could extend my wi-fi range. I managed to set these up (although the documentation is poor), however I cannot pair them with the TP-Link homeplugs. I've tried factory resetting the TP-link equipment but to no avail. If I connect one TP-link plug to my router I can use the other TP-Link kit to access a wired device, so I seem to end up with two pairs of homeplugs, neither of which will communicate with the other pair.
What can I do to get all 4 working together?
Model : TL-PA2010
Hardware Version : V1
Firmware Version :
ISP :
I had a pair of TP-Link TL-PA201homeplugs set up on my home network. These helped extend network to a wired device in another room.
I bought a set of Linksys PLE400 and PLW400 so I could extend my wi-fi range. I managed to set these up (although the documentation is poor), however I cannot pair them with the TP-Link homeplugs. I've tried factory resetting the TP-link equipment but to no avail. If I connect one TP-link plug to my router I can use the other TP-Link kit to access a wired device, so I seem to end up with two pairs of homeplugs, neither of which will communicate with the other pair.
What can I do to get all 4 working together?