Wavlink ac1200
I use an ac1200 as a lan bridge to extend the WiFi range in my property.
It works really well.
However on 2 occasions the device has reset itself back to factory default settings... Which means a load of cameras etc go offline.
I have no idea why this occurs
Any advice?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Note that this forum is dedicated to products made by TP-Link.
Perhaps you are better off contacting Wavlink's technical support. https://www.wavlink<dot>com/en_us/support/index (replace <dot> with . )
- Copy Link
- Report Inappropriate Content
Hi,
Note that this forum is dedicated to products made by TP-Link.
Perhaps you are better off contacting Wavlink's technical support. https://www.wavlink<dot>com/en_us/support/index (replace <dot> with . )
- Copy Link
- Report Inappropriate Content
woozle wrote
Hi,
Note that this forum is dedicated to products made by TP-Link.
Perhaps you are better off contacting Wavlink's technical support. https://www.wavlink<dot>com/en_us/support/index (replace <dot> with . )
Many thanks
I will.
I was under the impression that I was on a wavlink forum.
Senior moment
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 88
Replies: 2
Voters 0
No one has voted for it yet.