Diablo 4 on PS5 breaks internet connection
When launching Diablo 4 on my PS5 connected wirelessly to my Deco mesh I get an error and right after that the PS5 connectivity is cmpromised.
At PE5 start the console is properly connected.
It's a deco problem because if I bypass them and go straight to the isp router with an Ethernet cable everything works fine.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@ImtiazAli thank you for your answer the deco model is X50
Port forwarding is not currently enabled: in some blogs I've found it might be risky so I've been hesitant to do. Also I'm not an expert in this matter.
- Copy Link
- Report Inappropriate Content
@SamCur You can use your Deco X50 into AP Mode because in AP Mode your connected devices will get ip address directly from ISP router.
- Copy Link
- Report Inappropriate Content
@ARGamingPK1 thank you if I am not mistaken this working mode will limit some of the Deco advanced functionalities like parental controls device isolation and so on... the deco mesh will be basically just an extension if the isp router... am I right?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@SamCur You can try to connect your PS5 by using a LAN cable then try.
- Copy Link
- Report Inappropriate Content
@SamCur You don't have to enable port forwarding, just make sure that "SIP ALG" & "UPNP" both are enabled.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 184
Replies: 7
Voters 0
No one has voted for it yet.