Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > DECO X50-POE No se conecta por cable?

< Deco

DECO X50-POE No se conecta por cable?

DECO X50-POE No se conecta por cable?

DECO X50-POE No se conecta por cable?

Wednesday - last edited an hour ago

Posts: 1

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2025-03-12

DECO X50-POE No se conecta por cable?

Wednesday - last edited an hour ago

Tags: #Network Connectivity #Access Point Mode #Installation #2.5 Gbps

Model: Deco X50 - PoE

Hardware Version:

Firmware Version: 1.4.7

Hola a todos. Tengo dos deco x50-poe instalados. Ambos coenctados por cable eth.

Básicamente la red es, router, sw y los dos decos conectados a ese switch poe.

Inicialmente me tomo un deco principal y el otro conectado por cable funcionando todo bien.

Hoy se actualizo y me aparece conectado por wifi en vez por eth.

PQ puede ser es posible forzar que sea por cable? ya que un ap del otro de encuentran alejados y llega con muy poca señal la conexion entre ellos.

1

1

#1

1 Accepted Solution

Thursday - last edited an hour ago

Posts: 13656

Helpful: 1957

Solutions: 1492

Stories: 9

Registered: 2020-04-14

Re:DECO X50-POE No se conecta por cable?-Solution

Thursday - last edited an hour ago

Hi, welcome to the community.

Did you set Deco X50-PoE into Access Point mode under Deco APP>More>Advanced>Operation Mode?

(Since both X50-PoEs are connected to the switch, Access Point is necessary for Deco.)

As for the "update" mentioned here, is it a software/firmware upgrade to Deco X50-PoE?

Can I have the model number of the network switch here?

It is also suggested to replace a new cable to connect the satellite X50-PoE to another Ethernet port on the switch.

Wait for your reply and best regards.

▶Deco BE11000/ BE63_V2.6_1.1.7 Ready for Test ▶Deco BE25_V1_1.0.17 Ready for Test! ▶Deco M5 Newly Introduced Advanced Parental Control Features Try to leave a Message if urgent help is required.

Recommended Solution

0

0

#2

1 Reply

Thursday - last edited an hour ago

Posts: 13656

Helpful: 1957

Solutions: 1492

Stories: 9

Registered: 2020-04-14

Re:DECO X50-POE No se conecta por cable?-Solution

Thursday - last edited an hour ago

Hi, welcome to the community.

Did you set Deco X50-PoE into Access Point mode under Deco APP>More>Advanced>Operation Mode?

(Since both X50-PoEs are connected to the switch, Access Point is necessary for Deco.)

As for the "update" mentioned here, is it a software/firmware upgrade to Deco X50-PoE?

Can I have the model number of the network switch here?

It is also suggested to replace a new cable to connect the satellite X50-PoE to another Ethernet port on the switch.

Wait for your reply and best regards.

▶Deco BE11000/ BE63_V2.6_1.1.7 Ready for Test ▶Deco BE25_V1_1.0.17 Ready for Test! ▶Deco M5 Newly Introduced Advanced Parental Control Features Try to leave a Message if urgent help is required.

Recommended Solution

0

0

#2