WDS between TPLINK WD8961ND and iBall Baton WRX-150N
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WDS between TPLINK WD8961ND and iBall Baton WRX-150N
Region : India
Model : TD-W8961ND
Hardware Version : V3
Firmware Version : 3.0.0 Build 120524 Rel.05221
ISP : airtel
I am trying to extend the WIFI range using WDS.
My base router is TPLINK TD-W8961ND and is connected to Airtel Broadband and has been working fine as a ADSL router. All devices at home are able to access Internet through wifi.
I have an iBall Baton WRX-150N Wireless Router that support WDS which I am using as the 2nd router. Even after setting everything as per your FAQ and many other suggestions on the internet, I am not able to connect them. The configuration details are given below
TPLink Base Router Config
IP Address : 192.168.1.2, DHCP enabled Pool Starting 192.168.1.100
WDS enabled and MAC address of Router-2 (IBall) keyed in
iBall 2nd Router Config
IP Address : 192.168.1.1, dhcp disabled. in wds config, ssid, mac address and password for TPlink router is given.
both the SSID are the same, both are set in the same channel, and both are configured with WPA2
After above config, I am still not able to ping the TPlink from my iBall.
Please suggest is there anything else in the setting or does any of the routers need any different firmware.
Model : TD-W8961ND
Hardware Version : V3
Firmware Version : 3.0.0 Build 120524 Rel.05221
ISP : airtel
I am trying to extend the WIFI range using WDS.
My base router is TPLINK TD-W8961ND and is connected to Airtel Broadband and has been working fine as a ADSL router. All devices at home are able to access Internet through wifi.
I have an iBall Baton WRX-150N Wireless Router that support WDS which I am using as the 2nd router. Even after setting everything as per your FAQ and many other suggestions on the internet, I am not able to connect them. The configuration details are given below
TPLink Base Router Config
IP Address : 192.168.1.2, DHCP enabled Pool Starting 192.168.1.100
WDS enabled and MAC address of Router-2 (IBall) keyed in
iBall 2nd Router Config
IP Address : 192.168.1.1, dhcp disabled. in wds config, ssid, mac address and password for TPlink router is given.
both the SSID are the same, both are set in the same channel, and both are configured with WPA2
After above config, I am still not able to ping the TPlink from my iBall.
Please suggest is there anything else in the setting or does any of the routers need any different firmware.
