@David-TP The link for FW Deco BE25_V1_1.0.17 Ready for Test! is not available? 

Looks like a solid update with some useful fixes! Improved roaming and enhanced wireless connections should make a noticeable difference in daily use Personalized numerology destiny chart.

  @David-TP Hello everyone.. Do we know when this will be made official and no longer beta? 

I'm still getting some random dropouts on WIFI during heavy use. 

I've replaced my backbone cable and no longer getting speed related messages in the app..

  @David-TP 

Hello!

My Deco network is built from one pcs of S7 and two M4s.

When my laptop is changing from one to an other Deco the connectio is disconnected.

This is valid still the last sw update, before it no disconnection was observed.

Please help to solve the issue!

B.R.

Nad

  @David-TP    My dropouts seem to mainly occur when using Teams on conference calls. Almost guaranteed now... When looking at the app yesterday during the time it had happened, it reported that there were 0 connections on my 2 downstream devices in the office and lounge room - and that all devices appeared to connect to the main one in the bedroom. 30 seconds later it was all kind of back to normal again. There was no other activity in the house (streaming etc). 

It was also occuring on my Mac book Air m4 - and also on the 5Ghz band. I'll moved to 6Ghz and see if there is still issues. 

I think the app is about 30 seconds behind what is actually happening due to refreshes etc, but wanted to mention this. 

The Deco's were still all green and nothing obvious wrong. Never any issues streaming Netflix/YouTube on many of the other devices in the house during the same time either. 

Beamforming and Fast Roaming are on - Turning off Fast Roaming - what would this reduce? 

Keen to get the real version of 1.1.7/

Cheers

Greg.

  @David-TP Thanks for your note.

Yes, still seeing stability issues with teams calls. 

I've just run new cat6 over the weekend. I now have 

DSL > Modem > Bedroom BE 65 {1.1.7} ----cat 6---- Living Room BE 65 {1.1.7} ----- cat 6----- Office BE 65 {1.1.7}  XXXX WIFI XXX Garage BE 25 {1.0.17}

I'm noticing that I need to start the devices in a certain order... I need to start the bedroom one, let it settle, then start the living room one, then wait until its green, and then start the office device. 

However, in the APP, it draws the design as both the living room deco and the office deco directly connected to the BEDROOM deco. Not really the physical design - but maybe logical? 

The garage often jumps to the bedroom deco - and not the Office for which I've selected.. The signal is further/weaker than the office deco (I can see the icon is green vs yellow) but it's stubborn and wont always jump to the preferred one. 

I was having teams calling issues on my company HP laptop as well as my Mac. If I thether through my mobile, the errors/dropouts were no longer an issue. These calls run for over an hour, I would see dropouts/rejoins at least 5 times in that period. 

On a separate note - I did see some weirdness, where when the bedroom wasn't physically connected to the living room, the Sonosnet seems to run a connection/loop giving the error in the app that there is a low speed connection. However, after reconnecting the back haul to the 3 main devices, the error message went away.