Home Network Community > Wi-Fi Routers > Brand New WR902AC(US) v.4 boot looping?
< Wi-Fi Routers

Brand New WR902AC(US) v.4 boot looping?

Brand New WR902AC(US) v.4 boot looping?

Brand New WR902AC(US) v.4 boot looping?
Brand New WR902AC(US) v.4 boot looping?
2025-02-10 02:50:20 - last edited 2025-03-20 07:49:20
Model: TL-WR902AC  
Hardware Version: V4
Firmware Version: ?

I just purchased a WR902AC but I haven't been able to configure it.  I suspect it may be boot looping.

 

The LEDs are repeatedly blinking in sequence: all LEDs on, then only power LED on, then all LEDs off.

 

The device has been power for well over an hour, but is still showing the same pattern.  The device is powered by the provided adapter.  Although the device appears to respond to pressing the reset button by pausing the sequence, after several seconds, the pattern resumes.

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Brand New WR902AC(US) v.4 boot looping?-Solution
2025-02-10 22:06:00 - last edited 2025-03-20 07:49:20

  @krawetz 

 

If the device is brand new, your best approach would be to contact your retailer for a replacement or your local support.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Brand New WR902AC(US) v.4 boot looping?-Solution
2025-02-10 22:06:00 - last edited 2025-03-20 07:49:20

  @krawetz 

 

If the device is brand new, your best approach would be to contact your retailer for a replacement or your local support.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 146

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.