AP Isolation doesn't work
I have the ''AP Isolation'' feature enabled, but I'm still able to see & connect to all the devices on my wireless network. What can I do to avoid this ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Yes, the settings are saved correctly.
I wasn't aware that AP isolation doesn't work across bands. The devices were on different bands. Apparently, it only works when both the devices are on the same band (either 2 or 5 GHz).
- Copy Link
- Report Inappropriate Content
Hi@asish17,
Please confirm whether the setting is saved correctly? Please save the AP isolation setting, restart the router and test again. You can also disconnect the WiFi and reconnect to see if the problem still exists?
In addition, what are your wireless clients? What devices are they?
- Copy Link
- Report Inappropriate Content
Yes, the settings are saved correctly.
I wasn't aware that AP isolation doesn't work across bands. The devices were on different bands. Apparently, it only works when both the devices are on the same band (either 2 or 5 GHz).
- Copy Link
- Report Inappropriate Content
Hi@asish17,
We're thrilled to announce the release of the pre-release firmware for Archer AX53/AX58 V1. This firmware update introduces several exciting new functions and improvements to enhance your experience including Ethernet Backhaul, EasyMesh in AP mode, Satellite Router Management, ECO Mode, etc. We encourage you to try out this version of firmware and take advantage of the following features. Your feedback and suggestions are greatly appreciated.
Pre-release Firmware for Archer AX53/AX58 Supports EasyMesh in AP Mode, Ethernet Backhaul, ECO Mode
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 349
Replies: 3
Voters 0
No one has voted for it yet.