Easymesh between RE315 and NX200
I am trying to setup easy mesh between re315 and nx200 but the re315 just see itself as a range extender and puts _EXT on the end of the ssid
I have upgraded firmware to 1.0.30 and hard reset it and it still fails. Tried both was and doing it on box.
Neither one can see the other when checking easymesh links/view/scans
Hi,
Try if the following method works.
1. Verify EasyMesh is switched on in the settings of the NX200.
2. Switch "Band Steering" off on the NX200. (for the location of this option refer to the picture below)
3. Reset the RE315 to factory default settings (either via the webGUI or by pressing the small reset button located inside the small hole) and then wait a minute or two to allow it to boot up again.
4. Press the "WPS" button on the rear side of the NX200 and right after that press the WPS button (the one with the lock sysmol) on the RE315.
